How I Do It

At Diamondboi Designs I implement the latest in JewelCAD software to design your original piece of jewellery.  I generate a precise 3D concept of your piece, which is then sent to you for your approval. I will make as many changes or adjustments as is necessary to meet your satisfaction. This tool is far more efficient than the traditional method of hand-carving a wax model. By using this cutting-edge design technology, I can ensure that your piece will be structurally sound and cut to perfection. Once the wax model has been created, I will meet with you for your final approval before moving on to the next stage.​​​​​​​​​​​​

Every diamond used for my pieces must first pass through my stringent quality control standards. All diamonds are calibrated to .01 of a milimeter and are painstakingly matched in colour and clarity. If a single diamond slips through the cracks in the production stage of your piece, I will have it removed and replaced with a diamond that meets my exemplary standards.



There are several ways of setting diamonds; the cheapest way is to set the diamonds directly into the wax model. This is the method used for the majority of jewellery found in stores today.  This is a very insecure way of setting the diamonds.  With wear and tear, the diamonds will eventually fall out.

At Diamondboi Designs, I set my diamonds into the gold using a microscope at 50x magnification. This is by far the most secure method of setting. I go the extra mile to make certain that your piece of jewellery will be immaculate in every way.​

2019  By Diamondboi Designs - A division of The Diamond Studio Inc  All Rights Reserved

TEL: 647.972.RING (7464)  EMAIL: diamondboi@diamondstudio.ca